hardware:supported_mixing_consoles
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hardware:supported_mixing_consoles [2016/01/08 11:47] – [OnAir 2000] tw | hardware:supported_mixing_consoles [2019/09/10 15:54] – [RM3200D] tw | ||
---|---|---|---|
Line 10: | Line 10: | ||
===== DHD ===== | ===== DHD ===== | ||
- | ==== Series 52 (All models - 52/SX, 52/RX, etc.) ==== | + | ==== Series 52 (All models - RX2, SX2, 52/TX, 52/ |
Status: supported | Status: supported | ||
Console can be attached via TCP/IP or serial port. | Console can be attached via TCP/IP or serial port. | ||
+ | |||
+ | Ember+ protocol can be used simultaneously for additional functionality, | ||
==== RM4200D ==== | ==== RM4200D ==== | ||
Line 26: | Line 28: | ||
Status: limited support | Status: limited support | ||
- | Serial port only. Uses a subset of the RM4200D/52 packets, with a slightly different serial protocol. Set " | + | Serial port only. Uses a subset of the RM4200D/52 packets, with a slightly different serial protocol. Set correct console type in DHD remote |
==== RM2200D ==== | ==== RM2200D ==== | ||
- | Status: | + | Status: |
- | Uses an entirely different protocol than the other models. No plans to add support. | ||
===== Lawo ===== | ===== Lawo ===== | ||
Line 39: | Line 41: | ||
==== sapphire ==== | ==== sapphire ==== | ||
+ | |||
+ | Status: supported | ||
+ | |||
+ | ==== ruby ==== | ||
Status: supported | Status: supported | ||
Line 50: | Line 56: | ||
Status: supported | Status: supported | ||
- | ==== JADE Studio ==== | + | ==== R3LAY VRX (formerly |
Not a hardware mixing console but a software solution. Provides 8 GPIOs over Ember+. | Not a hardware mixing console but a software solution. Provides 8 GPIOs over Ember+. | ||
Line 72: | Line 78: | ||
==== Airmate, Airmate USB ==== | ==== Airmate, Airmate USB ==== | ||
- | Status: not supported | + | Status: |
USB connection is only for audio; needs external interface for fader start. | USB connection is only for audio; needs external interface for fader start. | ||
+ | ==== Webstation ==== | ||
+ | |||
+ | Status: supported (from v6.1) | ||
===== Studer ===== | ===== Studer ===== | ||
==== OnAir 500 ==== | ==== OnAir 500 ==== | ||
- | Status: not supported | + | Status: |
==== OnAir 1000 ==== | ==== OnAir 1000 ==== | ||
Line 111: | Line 120: | ||
Uses SAS over TCP/IP or serial port. | Uses SAS over TCP/IP or serial port. | ||
+ | |||
+ | ===== Axia ===== | ||
+ | |||
+ | ==== Livewire ==== | ||
+ | |||
+ | Status: supported | ||
+ | |||
+ | Uses the Axia TCP/IP Direct Interface on localhost port 93. | ||
===== Wheatstone ===== | ===== Wheatstone ===== |
hardware/supported_mixing_consoles.txt · Last modified: 2019/09/10 16:00 by tw