hardware:supported_mixing_consoles
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| hardware:supported_mixing_consoles [2015/02/11 21:46] – [Lawo] tw | hardware:supported_mixing_consoles [2019/09/10 15:55] – [OnAir 3000] tw | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| ===== DHD ===== | ===== DHD ===== | ||
| - | ==== Series 52 (All models - 52/SX, 52/RX, etc.) ==== | + | ==== Series 52 (All models - RX2, SX2, 52/TX, 52/ |
| Status: supported | Status: supported | ||
| Console can be attached via TCP/IP or serial port. | Console can be attached via TCP/IP or serial port. | ||
| + | |||
| + | Ember+ protocol can be used simultaneously for additional functionality, | ||
| ==== RM4200D ==== | ==== RM4200D ==== | ||
| Line 26: | Line 28: | ||
| Status: limited support | Status: limited support | ||
| - | Serial port only. Uses a subset of the RM4200D/52 packets, with a slightly different serial protocol. Set " | + | Serial port only. Uses a subset of the RM4200D/52 packets, with a slightly different serial protocol. Set correct console type in DHD remote |
| ==== RM2200D ==== | ==== RM2200D ==== | ||
| - | Status: | + | Status: |
| - | Uses an entirely different protocol than the other models. No plans to add support. | ||
| ===== Lawo ===== | ===== Lawo ===== | ||
| Line 39: | Line 41: | ||
| ==== sapphire ==== | ==== sapphire ==== | ||
| + | |||
| + | Status: supported | ||
| + | |||
| + | ==== ruby ==== | ||
| Status: supported | Status: supported | ||
| Line 50: | Line 56: | ||
| Status: supported | Status: supported | ||
| - | ==== JADE Studio ==== | + | ==== R3LAY VRX (formerly |
| Not a hardware mixing console but a software solution. Provides 8 GPIOs over Ember+. | Not a hardware mixing console but a software solution. Provides 8 GPIOs over Ember+. | ||
| Line 72: | Line 78: | ||
| ==== Airmate, Airmate USB ==== | ==== Airmate, Airmate USB ==== | ||
| - | Status: not supported | + | Status: |
| USB connection is only for audio; needs external interface for fader start. | USB connection is only for audio; needs external interface for fader start. | ||
| + | ==== Webstation ==== | ||
| + | |||
| + | Status: supported (from v6.1) | ||
| ===== Studer ===== | ===== Studer ===== | ||
| ==== OnAir 500 ==== | ==== OnAir 500 ==== | ||
| - | Status: not supported | + | Status: |
| ==== OnAir 1000 ==== | ==== OnAir 1000 ==== | ||
| - | Status: supported | + | Status: supported |
| Uses SAS over serial port. | Uses SAS over serial port. | ||
| Line 96: | Line 105: | ||
| ==== OnAir 2000 ==== | ==== OnAir 2000 ==== | ||
| - | Status: supported | + | Status: supported |
| Uses SAS over serial port. | Uses SAS over serial port. | ||
| Line 111: | Line 120: | ||
| Uses SAS over TCP/IP or serial port. | Uses SAS over TCP/IP or serial port. | ||
| + | |||
| + | ==== Micro ==== | ||
| + | |||
| + | Status: not supported | ||
| + | |||
| + | Has no remote control over TCP or serial or USB at all. Only physical GPIO and Web. | ||
| + | ===== Axia ===== | ||
| + | |||
| + | ==== Livewire ==== | ||
| + | |||
| + | Status: supported | ||
| + | |||
| + | Uses the Axia TCP/IP Direct Interface on localhost port 93. | ||
| ===== Wheatstone ===== | ===== Wheatstone ===== | ||
hardware/supported_mixing_consoles.txt · Last modified: 2019/09/10 16:00 by tw