config:remotecontrol:k8055
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
config:remotecontrol:k8055 [2016/08/29 20:21] – [Supported Hardware] tw | config:remotecontrol:k8055 [2019/07/09 16:18] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 18: | Line 18: | ||
===== Configuration ===== | ===== Configuration ===== | ||
+ | Open the standalone config app, or the Control Panel, go to the //Remote Control// section, and add a new //Vellemann K8055(N)// remote. | ||
+ | |||
+ | The configuration dialog will look like this: | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | First, you can set up the **device address** (corresponds to the jumpers on the board) and the **update interval** for polling. | ||
+ | |||
+ | Then you can assign a command for each input 1-5, and for the event that the pin goes ON or OFF, respectively. | ||
===== Scripting ===== | ===== Scripting ===== | ||
config/remotecontrol/k8055.txt · Last modified: 2022/08/25 15:12 by tondose