config:remotecontrol:dhd
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
config:remotecontrol:dhd [2017/11/24 12:16] – tw | config:remotecontrol:dhd [2018/10/06 18:39] – [DHD Series 52, RM4200D, RM3200D] tw | ||
---|---|---|---|
Line 3: | Line 3: | ||
This article covers remote control of mAirList with digital broadcast consoles from [[http:// | This article covers remote control of mAirList with digital broadcast consoles from [[http:// | ||
- | The information in this article is current as of: mAirList 5.2 beta | ||
===== Supported Hardware ===== | ===== Supported Hardware ===== | ||
Line 9: | Line 8: | ||
The DHD remote control interface in mAirList supports the following consoles from DHD: | The DHD remote control interface in mAirList supports the following consoles from DHD: | ||
- | * Series 52 (all models: 52/MX, 52/RX, 52/SX, 52/DX, 52/ | + | * Series 52 (all models: 52/MX, 52/RX, 52/SX, 52/DX, 52/ |
* RM4200D | * RM4200D | ||
* RM3200D | * RM3200D | ||
- | Note: The RM2200D | + | For the RM2200D, see [[dhd2200|here]]. |
===== Configuration ===== | ===== Configuration ===== | ||
Line 158: | Line 157: | ||
{{ : | {{ : | ||
- | ==== DHD Console ==== | + | ===== DHD Console ====== |
+ | |||
+ | The DHD Console provides manual remote control of your DHD mixer from the mAirList playout application. It is located in the menu next to the // | ||
+ | |||
+ | ==== Console ==== | ||
+ | |||
+ | On the first tabs, you see a representation of the fader strips of your console, each with a PFL button, channel label, volume slider, and ON/OFF button. | ||
{{ : | {{ : | ||
+ | Right-click the channel label to select another input channel for that fader. | ||
+ | |||
+ | The controls are fully bi-directional, | ||
+ | |||
+ | ==== Logic ==== | ||
+ | |||
+ | The //Logic// tab provides 20 buttons that can be used to control logic states in your DHD console. | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | Right-click a button to adjust its properties: | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | Set the label, the logic ID (as found in the Toolbox project) and the mode (toggle, tally or inverse tally). The buttons can also indicate logic states by changing their color. To use this function, enter a logic ID to be used as the lamp source, and select a color. | ||
+ | |||
+ | ==== Monitor ==== | ||
+ | |||
+ | The third tab shows a list of messages sent to and received from the DHD core, for debugging purposes, similar to the //Monitor// tab of the remote control configuration when opened through mAirList Control Panel. | ||
+ | |||
+ | {{ : | ||
===== Actions ===== | ===== Actions ===== | ||
config/remotecontrol/dhd.txt · Last modified: 2019/10/28 06:22 by tondose