config:remotecontrol:airlab
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
config:remotecontrol:airlab [2016/09/01 07:13] – tw | config:remotecontrol:airlab [2019/07/09 16:18] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== D&R AIRLAB | + | ====== D&R AIRLAB Remote Control ====== |
+ | The [[http:// | ||
+ | |||
+ | ===== Supported Hardware ===== | ||
+ | |||
+ | * AIRLAB Mk 2 | ||
+ | * AIRLAB DT | ||
+ | |||
+ | ===== Fader Start Configuration ===== | ||
+ | |||
+ | The AIRLAB has a serial port used for fader starts. You need a physical serial port, or a USB/serial adapter, on your computer. | ||
+ | |||
+ | (Depending on your hardware configuration, | ||
+ | |||
+ | The first step is to set the serial communication parameters correctly. Open the mAirList standalone config app, go to //Misc. -> Serial Ports//, and set the parameters of the corresponding port as follows: | ||
+ | |||
+ | * Baud rate: 57600 | ||
+ | * Byte size: 8 | ||
+ | * Parity: N | ||
+ | * Stop bits: 1 | ||
+ | * Receive buffer: 4096 | ||
+ | * Send buffer: 4096 | ||
+ | |||
+ | Next, go to the //Remote Control// page, and add a new //D&R Airlab// remote. | ||
+ | |||
+ | ==== Communication ==== | ||
+ | |||
+ | On the // | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | Don't forget to set the communication parameters on the //Serial Ports// page correctly, see above. | ||
+ | |||
+ | ==== Channels ==== | ||
+ | |||
+ | On the // | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | Just select or type any [[reference: | ||
+ | |||
+ | ==== On Air ==== | ||
+ | |||
+ | The AIRLAB has two On Air busses which can be switched separately. On the //On Air// tab, you can assign remote control commands to these switching events: | ||
+ | |||
+ | {{ : | ||
+ | ===== USB Control Module ===== | ||
+ | |||
+ | D&R offers an optional USB Control Module with 16 cartwall push buttons and 8 additional customizable keys. | ||
+ | |||
+ | This module is compatible with the similar control module of the D&R AIRENCE control. To use it with mAirList, just follow the instructions for the setup of the [[config: | ||
+ | |||
+ | So if you are using an AIRLAB with the USB Control Module, you will need to add two remote controls to your mAirList configuration: |
config/remotecontrol/airlab.1472714000.txt.gz · Last modified: 2019/07/09 16:18 (external edit)